Motortester DIAMAG 3 Full is a professional motor tester for fast and accurate fault detection in any engine of any car. The Diamag 3 software has all the functions that a modern motor tester should have. The six-channel oscilloscope is able to check the ignition and valve systems, the correct installation of the belt or timing chain, compression, scroll current and other parameters.
The device has a very durable aluminum housing that will protect it from mechanical damage. The case is also a shield against interference. The device has a low level of its own noise.
The main differences between Diamag 3 and Diamag 2:
- All channels now have 1 MHz bandwidth.
- The maximum digitization frequency is 7.2 MHz:
- 7.2 MHz (in single-channel mode)
- 3.6 MHz (in 2-channel mode)
- 2 MHz (in 3-channel mode)
- 1 MHz (in 4...6 channel mode)
- The bit depth of the ADC is 12 bits.
- There is a galvanic isolation for power supply.
- The 6th and D have an additional amplifier 2, 5, 10 times.
- In order to increase noise immunity, the transition from the USB interface to a network 100 Mbit Ethernet was carried out. The new motor tester can be connected directly to a computer, as well as to a Wi-Fi router, which is very convenient — your laptop is not wired to a Diamag. With this connection, a 5 volt cell phone power supply can be used to power the device.
- The device does not require drivers, as it uses a network interface.
- The device is powered via a network patch cord from a free USB port.
- When using channel 4, an additional slow ADC is used to synchronize with the peak detector turned on, so that the synchronization channel does not affect the overall digitization frequency.
- Power protection has been made, nothing will happen with a short-term reverse polarity of the power supply. During prolonged operation, only the protective resistor will fail.
More information here: Motortester DIAMAG 3 Full
