Bosch MEDC17 Bench [SM2 ONLY]

FID: 407

Universal module for BENCH reading and writing for Bosch ME(D)17 and EDC17 ECUs based on Infineon TC17xx.

Allows reading and writing flash and EEPROM on the bench with auto detection of MCU type and file size by using Bosch Service Mode (BSM). Checksum fix is performed on writing. No open ECU needed. Connection is only on the bench.

Supported MCUs: TC1724, TC1728, TC1762, TC1766, TC1767, TC1782, TC1792, TC1793, TC1796, TC1797

Supported ECUs: Click to see list of supported ECUs

New ECUs support will be added.

Attention! Read before purchasing:

• Module works only with Scanmatik SM2 or SM2 Pro.
• This FID is not suitable for cloning ECU because there are protected OTP sectors. Also sectors (0x10; 0x20) are skipped during writing operation in order to avoid bricking ECUs.
• On some ECUs checksums calculation may take a long time. It depends on the configuration of your computer.
• In case of an identification error, check your connection, and also change the places of the GPT wire.
• All tested adapters with automatic power management with wires for the GPT signal output available here