The device serves as an interface for connecting to an ECU "on the bench." Internet access is required for MMC Flash Hardware to operate. The device is purchased only once and only together with one or more modules.
Subscription to MMCFlash solutions is valid for 30 days, limited to 1 solution per day.
Technical support is provided by the developer directly.
Identification, Full image data writing and reading, Calibration data writing and reading, EEPROM reading and writing, Checksum calculation,
Identification, Full image data writing, Calibration data writing, EEPROM reading and writing
Full image data writing and reading
The MMCFlash Kokusan R5F2136Cx module is designed to work with electronic control units (ECUs) in the "on the bench" mode.
The module provides support for reading and writing ECUs, making it a convenient tool for tuning and diagnostics.
The solution is fully compatible with MMCFlash HardWare software and is suitable for specialists involved in ECU repair and calibration.
Identification, Full image data writing and reading, Calibration data writing and reading, EEPROM reading and writing, Checksum calculation
The MMCFlash Kubota Denso RH850 module is designed for flashing (tuning/ecology), recovery and cloning Denso RH850 ECUs installed on Kubota.
The module only works with the ECU open. Wiring diagrams are provided after purchase.
This solution is designed for professionals who repair, tune, and clone Denso RH850 ECUs. The module is fully compatible with MMCFlash HardWare and ensures stable operation with this processor.
The MMCFlash Nissan/Infiniti Hitachi SH705x module is designed to recovery electronic control units (ECUs) of Nissan and Infiniti vehicles on Renesas SH7054, SH7055, SH7058, and SH7059 processors.
The module only works with the ECU opened. Wiring diagrams are provided after purchasing the module. Only data writing is supported; reading is not available.
This solution is recommended for specialists repairing and recovery Nissan and Infiniti ECUs. The module is fully compatible with MMCFlash HardWare software and ensures stable operation with SH705x series microcontrollers.
Identification, Full image data writing, Calibration data writing, EEPROM reading and writing
Valid for 30 days, limited to 1 solution per day. Editing ecu files with a 20% discount. Possibility to use the automatic service daily without additional charges.
