CAN filter allowing to stop Mileage counting, mileage blocker works as CAN blocker, stop odometer device. This device is used to stop the odometer counter by directly blocking the mileage data from reaching the odometer. Works as CAN (Controller Area Network) module that is installed behind the dashboard. Can be switched on and off. Mode switching is confirmed by the flashing of a hazard light. Works on all Mercedes-Benz "GLE Coupe" (C292) cars manufactured from 2015 to 2019.
TROUBLESHOOTING: On most car models, both connectors, male and female, can be connected both ways. Hence, most of the troubleshooting is done by simply reconnecting the device. Thus, if you you don’t get an LED light on the device: flip the male connector 180 degrees / if the instrument panel does not light up after connecting the device: flip the female connector 180 degrees.
Please note, if the device is connected incorrectly, it will not cause any damage to the car's electronic system.
Press and hold the "Mute" button on the right side of the steering wheel for 10 seconds.
There are no modes for Mercedes-Benz. The device is either "Off" on "On" stopping 100% of mileage.
To calibrate the speedometer arrow, press and hold the "+" button (on the left side of the steering wheel) for 5 seconds, after which the speed will begin to increase. Release the button when the desired value is reached. To reduce the speed, press and hold the "-" button. Perform speedometer calibration while on the road keeping the same speed.
The device remembers the last position of the speedometer needle after calibration.
NOTE: Remember to disable Cruise Control. Pull the Cruise Control lever (on the right under the steering wheel) towards you for 4 seconds.
There is a number of features that could be compromised when the device is active:
