18
November
2026
KESS3 Protocol Release
Back to press center

The possibilities for working on protected Bosch MG1CS201 control units, installed on numerous BMW, MINI and Toyota models, from entry-level to premium and sports models, are expanding.

The first operation requires accessing the control unit in BENCH mode with KESS3 to perform the dedicated unlocking procedure. Once this operation is complete, you can carry out all subsequent reading and writing operations directly through the OBD diagnostic port, without having to remove the ECU from the vehicle again.

The OBD protocol is also available for Powergate. This expands the possibilities for working beyond the workshop, allowing you to offer customers a more complete service, even remotely, through the device and the dedicated App.

A concrete advantage for managing daily operations: work on the bench only the first time and reduce the steps required for subsequent operations.

The benefits for your workshop:

  • fewer operational steps for subsequent operations: reading and writing directly in OBD after unlocking in BENCH
  • work on a wide range of petrol engines, from entry-level 1.5 engines to the powerful 4.4 V8 Bi-Turbo
  • new business opportunities on BOSCH «Locked» ECUs
  • new possibilities for working with Powergate.

 

Technical focus

 

Supported vehicles

 

Alientech KESS3 Master
Alientech KESS3 Slave

Registration
×
×
Password recovery
A password reset instruction will be sent to the email you provided during registration.
Recovery
Ready!
An email with a password recovery link has been successfully sent to your email address.
×
Thank you for the subscription!
Your Email has been added to the list. You will be the first to know about all the news!
×
Your message has been sent
Our specialist will contact you as soon as possible.
OK