This module is designed to read/write software and calibrations for SID212/EVO ECUs installed in Ford vehicles.
The ECU can be accessed in the following modes:
OBD: Reading (1 hour 50 minutes of software/calibration, 38 minutes of calibration) and writing (3 minutes of software/calibration, 1 minute of calibration) of the original ECU software/calibrations are available.
Bench: Reading (5 minutes of software/calibration, 2 minutes of calibration) of software/calibrations and writing (1 minute) of ECU calibrations are available.
Additional functions:
Caution! Exercise extreme caution when working with the ECU. A failure during writing is not destructive, but there are currently no ways to restore the ECU after writing incorrect data. Writing inappropriate software or incorrectly modified calibrations may render the ECU inoperable.
This module is designed for reading and writing MCM2.1 D4/D5 ECUs installed in Mercedes-Benz trucks.
The ECU can be accessed either without opening the module in OBD-Full mode or with opening in BSL mode. Identification and error reading/reset functions are also available.
The module automatically recalculates the calibration coefficients of written calibrations.
The module allows for complete reading and writing of the ECU contents.
MT05.3 Module
Designed for chip tuning Delphi MT05.3 ECUs installed on various types of motorcycles.
Supports reading full FLASH images and writing software and calibrations.
