Bosch MED 9.1 module for VAG vehicles with the 2.0 TFSI engine (EA113)

Key maps

• Boost and charge: base boost pressure with ambient pressure and intake air temperature correction, boost limits, overboost, maximum cylinder charge and its reduction by temperature and knock, requested engine load.
• Wastegate: duty cycle map, linearization, ambient pressure correction, duty cycle limit, PID controller parameters, alternative boost control map without torque coordination.
• N249 valve: compressor pressure ratio thresholds, dynamic diverter valve control.
• Torque: pedal torque request, optimum torque, torque limiters by gear, clutch protection, coolant and exhaust temperature, and brake pressed, maximum torque for normalization and for CAN output.
• Torque monitoring: maximum inner torque, tolerances, pedal position maps in the monitoring function.
• Ignition and knock: base, optimum and minimum ignition angle, including with closed intake manifold flaps, knock limit correction, retard step and maximum retard, per-cylinder knock detection factors, coil dwell time.
• Mixture and lambda: driver-requested lambda, component protection enrichment, exhaust gas temperature model, injection time corrections.
• High-pressure fuel: rail pressure setpoints, maximum rail pressure, HPFP parameters.
• Low-pressure fuel: target fuel pressure, fuel pump duty cycle.
• Injection timing: start of injection and its limit.
• Valve timing: intake camshaft setpoints.
• Intake system: intake manifold flap control, throttle, MAF sensor correction and calibration, boost pressure sensor calibration.
• RPM limiters: idle, stationary vehicle, by engine and oil temperature, overheat protection.
• Vehicle speed limiters: by engine and oil temperature, by ESP.
• Idle speed: after start, during catalyst heating, gear-dependent.
• Launch control: raised RPM limit, activation time and temperature conditions.
• Pops & Bangs: overrun fuel cut-off, cut-off delays, fuel resume thresholds.
• Left foot braking: throttle limitation conditions with brake pressed.
• Catalyst heating: conditions and coefficients.
• Cooling: fan duty cycle.
• Configuration: DTC (switches and OBD codes), catalyst and lambda sensor diagnostics, boost diagnostic thresholds, configuration bits.

ECU identification
TCEPro identifies the ECU from the firmware file automatically and opens the matching catalog. If a file does not open, send it to support and it will be added promptly.

Supported software versions

ECU part number · version · Bosch software number

Audi A3 (8P)

• 8P0907115H · 0040 · 1037387473
• 8P0907115R · 0010 · 1037386837
• 8P0907115T · 0010 · 1037387458
• 8P0907115AP · 0010 · 1037501227

Audi A4 (B7)

• 8E0910115B · 0120 · 1037387400
• 8E0910115B · 0130 · 1037390728
• 8E0910115B · 0140 · 1037399953
• 8E0910115L · 0060 · 1037386820
• 8E0910115P · 0020 · 1037386454
• 8E1910115 · 0030 · 1037386835
• 8E1910115B · 0020 · 1037386894

Audi A6 (C6)

• 4F2910115B · 0040 · 1037386852
• 4F2910115F · 0010 · 1037389427
• 4F2910115F · 0030 · 1037505742
• 4F2910115J · 0020 · 1037396795
• 4F2910115J · 0030 · 1037534098

Audi TT (8J)

• 8J0907115Q · 0010 · 1037393740

Volkswagen Golf V / Jetta / Eos

• 1K0907115A · 0070 · 1037387568
• 1K0907115B · 0040 · 1037391667

Volkswagen Scirocco

• 1K8907115D · 0030 · 1037510588

Volkswagen Passat (B6)

• 3C0907115F · 0020 · 1037387474
• 3C0907115F · 0030 · 1037391668
• 3C0907115R · 0020 · 1037386638
• 3C0907115S · 0020 · 1037391093

If your software version is not listed, send the file to support and it will be added.

Applicability

• Audi A3 (8P) 2.0 TFSI
• Audi A4 (B7) 2.0 TFSI
• Audi A6 (C6) 2.0 TFSI
• Audi TT (8J) 2.0 TFSI
• Volkswagen Golf V GTI / Jetta 2.0 TFSI
• Volkswagen Scirocco 2.0 TFSI
• Volkswagen Passat (B6) 2.0 TFSI
• Volkswagen Eos 2.0 TFSI
• Seat Leon / Altea / Toledo 2.0 TFSI
• Skoda Octavia RS 2.0 TFSI

The list of models and supported functions will keep expanding.