Ford Continental on SID212 and SID212EVO in Flex
With the new Flex update, version 7.59.0.0, working on Continental SID212 and SID212EVO control units installed on Ford vehicles is even faster and easier.
This release introduces direct access to the map area and the EEPROM memory without the need to unlock the unit: just connect the red OBD cable to the diagnostic port of the vehicle to start reading.
Moreover, operating times have also been optimized, allowing the file to be obtained even faster and improving workshop efficiency.
Main advantages:
- Direct access via OBD
- No need to unlock in Bench
- Map area and EEPROM read
- Reduced acquisition times
- Faster operations
Some of the supported vehicles
- Ford Ranger (T6) 2.0L TDCi EcoBlue 213 HP (2021MY)
- Ford Transit (MK9) 2.0L TDCi EcoBlue 106HP (2021MY)
- Ford Mondeo (IV) 2.0L TDCi EcoBlue 179HP (2021MY)
- Ford Kuga (III) 2.0L TDCi EcoBlue 150HP (2021MY)
- Ford Transit Custom (MK9) 2.0L TDCi EcoBlue 131HP (2021MY)
This new protocol is available for the following software packages:
OBD Full
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Bench
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
- FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
Newly added protocols:
OBD Full
- Ford Continental SID212 TC297 Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM
- Ford Continental SID212EVO TC297 Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM
Writing Time ~3 minutes and 30 seconds
Reaing Time ~2 minutes and 30 seconds
Bench
- Ford Continental SID212 TC297 Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM
- Ford Continental SID212EVO TC297 Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM
Writing Time ~3 minutes and 30 seconds
Reading Time ~2 minutes and 30 seconds
