OBD and Boot Modes Now Supported with Flex
Programming Continental M3D control units in OBD and Boot is now easy with Flex.
New release, version 7.55.0.0, out now dedicated to Ducati vehicles, introducing OBD communication via 4-pin MMS03.003 cable for Euro 4 models.
This new update allows to work directly via the diagnostic port of the vehicle, ensuring fast and safe operations. On one hand, you can efficiently perform the virtual read and write, optimizing operational time and workflow without the need to remove the unit.
The Boot mode, on the other hand, gives you full access to the ECU, thus enabling full backups. Thanks to this feature, you can restore the unit in case of data corruption, ensuring the highest safety in all the programming phases.
Supported Vehicles
- Ducati Hypermotard 950 (I) 937cc (E4) 113HP (2019MY)
- Ducati SuperSport 939 (I) 937cc (E4) 111HP (2017MY)
- Ducati Monster 1200 (II) 1198cc (E4) 148HP (2017MY)
- Ducati Scrambler 1100 (I) 1079cc (E4) 85HP (2017MY)
New protocol available for the following software packages:
OBD
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.13M – SW Flex Bikes OBD/Bench/Boot Master
- FLS0.13S – SW Flex Bikes OBD/Bench/Boot Slave
BOOT
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.13M – SW Flex Bikes OBD/Bench/Boot Master
- FLS0.13S – SW Flex Bikes OBD/Bench/Boot Slave
Newly added protocols:
OBD
Writing Time ~2 minutes and 30 seconds
BOOT
- Ducati Continental M3D MPC5534 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Full Backup
Writing Time ~20 seconds
Reading Time ~40 seconds
FLEX Master
FLEX Slave
