Download the newest version of the FLEX software and try out the protocols for Hitachi BED 430 and Hitachi BED 431 engine control units supported in OBD mode.
Get access to the map zone of the unit from the diagnostic port of Nissan vehicles, such as Juke and Qashqai with 1.6L DIG-T petrol engines and 2.0L hybrid-petrol engines: you will be able to change engine parameters according to your needs.
No need to remove the ECU from the vehicle: program it simply and rapidly from the OBD port of your car.
 
Some of the supported vehicles:

• Nissan X-Trail 2.0L CVT 110PS
• Nissan Qashqai 2.0L Hybrid CVT 132PS
• Nissan Teana 1.6L DIG-T 120PS
• Nissan Juke 1.6L DIG-T 120PS

This new protocol is available for the following software packages:

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
• FLS0.5M – SW Flex Full Master
• FLS0.5S – SW Flex Full Slave

Newly added protocols:

OBD

• Nissan Hitachi BED430 Read/Write/Checksum Calculation Maps
• Nissan Hitachi BED431 Read/Write/Checksum Calculation Maps

Reading Time ~ 2 minutes and 30 seconds Writing Time: ~ 1 minute and 30 seconds

Bug Fixes:

• Fixed authentication on Porsche Bosch MG1CS047
• Added Seedkey type for VAG Bosch MG1CS001_SPC
• Added new CRC type for PSA Delphi DCM7.1
• Added new CRC type for Kubota Denso SH72543

Software Improvements:

• Added support for Volkswagen Amarok EDC17CP54 2024

FLEX Master
FLEX Slave