1. Module 32 «Ford Focus 3 2015, Ford Explorer 2016, Ford Kuga 2 2017» now supports EMS2107 ECU installed on Ford Kuga hybrid vehicles 3. Supports reading, writing, and checksum checksums.
2. Support for the MT92.1E ECU installed in Changan CS75PLUS vehicles has been added to Module 51 «China». It supports reading, writing, and checksum checksums.
3. The Denso SH725xx/1N83M Bootloader module 80 has added support for Denso ECUs installed on Ashok Leyland and Isuzu trucks. Supports reading, writing, and checksum checksums.
4. In the module 83 «VAG Bosch DQ380/DQ381/DQ500/ZF 8HP», test support for the ZF 6HP automatic transmission control unit installed in Volkswagen and Audi vehicles: AL420/AL600 (09L/09E) has been added. Virtual reading and writing via K-Line and CAN TP2.0 protocols is supported, as well as checksum verification and correction.
5. Module 89 «China MG1» adds support for the MG1UA008 ECU used in BAIC vehicles, as well as UD8/MG1US008 in JAC vehicles. It supports reading, writing, and checksum checksums.
6. Module 90 «China DCM6.2AP/DCM7.1AP» now supports DCM6.2AP/DCM7.1AP ECUs used in Qingling/Isuzu vehicles. It supports reading, writing, checking and correcting checksums. In addition, test support for EEPROM operation of the DCM6.2AP ECU and some DCM7.1AP ECUs has been added.
7. In module 93 «India DCM7.1AP», support for DCM2.7AP/DCM7.1AP ECUs used in Mahindra vehicles has been added. It supports reading, writing, checking and correcting checksums. In addition, support for EEPROM operation for the specified ECUs has been added.
